PC 88 Hammer crusher

Detailed Product Description

This series of hammer crushers is suitable for crushing various brittle materials such as coal, salt, chalk, plaster stone, alumstone, brick, tile, limestone etc. Whose compressive resistance does not exceed 150Mpa and the moisture content should not be greater than15%.

Hammer Crusher working principle: The main wroking part of hammer crusher is rotos with hammer, the rorors consisf of main shaft, disk, pin shaft and hammers.The motor drives the motor drives the rotos to roate quickly in the crushing cavit. Raw naterials enter the crusher through the feedd opening and are stricken, impacted, cut and groun bu the high-speed hammer th small size. There is a screening palte under the rotor, so that materials with size smaller then the screen meh will be screened out and other are left to be further hammered and ground until reach the stand size. The size of the final product can be adjusted by changing the screenin plate. the gap between the rotors and the screening plate can also be adjusted according to different requirement.

 

Model	Rotor Working Wiameter Length(mm)	Speed of Rotor (r/min)	Size of Feed Opening(mm)	Max. Feed Size(mm)	Discharge Size (mm)	Capacity (t/h)	Motor Power (kw)	Weight (t)
PC-42	400/175	1000	150*260	50	3	0.5	5.5	0.5
PC-44	400/400	1500	220*450	100	10	5-8	7.5	0.9
PC-64	600/400	1000	295*450	100	15	10-12	18.5	1.03
PC-66	600/600	1000	250*570	100	10	12-18	45	2.14
PC-86	800/600	1000	350*570	200	10	20-25	55	2.45
PC-88	800/800	1000	350*770	200	15	35-45	55	3.05
PC108	1000/800	1000	580*850	200	13	25-40	110	6.5
PC-1010I	1000/1000	1000	580*1060	200	15	40-80	132	7.59
PC-1010||	1000/1000	1000	580*1060	200	10	30-50	160	7.59
PC-1010|||	1000/1000	1000	580*1060	100	<=5 80%	25-35	185	7.59
PC-1212	1250/1250	739	940*1430	200	20	100	180	19.1
PC-1414	1400/1400	740	860*1540	250	20	120-170	280	17.2
PC-1618	1600/1800	590	1260*1920	400	25	250-300	630	45